Using the Spa Heater normal pool operation
spa operation
1.Turn valves 180 degrees as pictured above.
2.Turn on heater (toggle switch above), make sure temperature dial is turned all the way to the left.
*** heater should turn on w/in 30 seconds
***wait until water is desired temperature before turning on air blower.
***wait until water is desired temperature before turning on air blower.
3.When done using spa, turn valves back to pool operation position.
***let pool pump run another ten minutes to allow pipes and heat exchanger to cool down
Lighting the Pilot
1.Read the instructions inside the heater (remove front panel by raising it up and pulling it out)
2.turn the gas valve to pilot.
3.Find the pilot generator ... bottom right behind pilot tube.
4.Using a long fireplace lighter, hold flame to pilot generator while holding down the gas valve in "pilot" position.
5.Continue holding down the gas valve in "pilot" position for 20 seconds or longer.
6.Release holding down valve & turn gas valve to "on" position.
7.look & check if pilot light stays lit.
8.Replace front panel on heater before flipping toggle switch to turn on heater.
***heater is ready to turn on.
No comments:
Post a Comment